LPG Toroidal Tanks Victron Lynx Smart BMS 500 NG (M10)

Details

Victron Energy Lynx Smart BMS 500 NG (M10) LYN034160310 EAN 8719076063551 lithium battery management system

The Victron Energy Lynx Smart BMS 500 NG (M10) with EAN 8719076063551 (part number LYN034160310) is the ultimate battery management system or BMS dedicated exclusively to the next generation Victron Lithium NG series. This lithium battery monitor and safety unit protects LiFePO4 or lithium iron phosphate battery banks operating at 12V, 24V, or 48V. The Lynx Smart BMS NG integrates flawlessly with the Lynx Distributor M10 busbar, offering advanced battery protection against overcharging, over-temperature, and deep discharge.

Key Features and Benefits

• Built-in 500A contactor acts as a safety disconnect and a remote-controllable main switch.

• Integrated pre-charge circuit prevents damaging inrush currents from capacitive loads like inverters.

• Advanced battery monitor displaying state of charge, voltage, current, and historical diagnostics.

• Innovative pre-alarm alert signal before low cell voltage shutdown occurs.

• Supports parallel redundancy, allowing up to 5 Lynx Smart BMS units in one single system.

• Bluetooth connectivity for the VictronConnect app alongside VE.Can and NMEA 2000 data communication.

• AUX terminal providing auxiliary power to a Cerbo GX device even after main shutdown.

Installation and Operating Instructions Mount the Victron Lynx Smart BMS 500 NG directly into your Lynx M10 modular distribution system. Connect the communication cables from your Lithium NG batteries to the BMS. Open the VictronConnect app via Bluetooth to complete initial setup and configure your system voltage. Connect the VE.Can bus to a central GX device like the Cerbo GX for local and remote monitoring. Ensure the ATC/ATD (Allow to Charge/Discharge) contacts are wired to your chargers and loads for automatic safety control.