Details
INSTRUCTION TO ASSEMBLE FLEXIBLE HOSE
- Cut the hose edge in a perpendicular way. Verify that there is no residual of protective covering. Position the nut and the bicone
- Block the connection in a vise. Position the hose on the connection edge. Push strongly the hose against the shoulder of the connection
-tective covering. Position the nut and the bicone
- Push the bicone against the shoulder of the connection
- Screw the nut on the connection against the shoulder of the connection
GENERAL INDICATION
- Tightening torque for the connections with a 18 mm wrench must be between 28 and 30 Nm
- Tightening torque for the connections with a 16 mm wrench must be between 23 and 25 Nm
- The minimun bending ray for the hoses with an external diameter of 12,2 mm is of 35 mm
- The minimun bending ray for the hoses with an external diameter of 9,6 mm is of 25 mm
- Do not place the hoses next to heat sources which are at more than 125°C
- We suggest to fasten the hoses with clamps every 50 cm
- We suggest to test the plant after assemblage